What is the precautions for using co2 laser marking machine
Many customer do not know how to use the co2 laser marking machine.In the fact,there are many precautions for using co2 laser marking machine.When we are using the machine,we should pay attention on it,so it will be more safe for us and good for the machine working life.
Co2 laser marking machine precautions
1. When using CO2 laser marking machine, it is forbidden to look up from the bottom of the laser vibrator, which may lead to the laser beam into the eye causing permanent damage.
2. Carbon dioxide CO2 laser marking machine should not be suddenly cut off when working, which may lead to the loss of laser software or even the computer can not be opened normally, the hardware part of the machine may also be damaged, it is recommended to equip with PUS power regulator.
3. Do not often move the CO2 laser marking machine to the position, because the optical accessories inside the machine at the factory when the position and Angle have been adjusted, often moving the position will lead to the internal parts due to the vibration of the Angle change, which leads to the normal use of the machine.
4. Disconnect the main power supply when not in use for a long time.
5. Do not browse the high dangerous website on the computer of the CO2 laser marking machine equipment, to prevent the virus after laser carving out the garbled code.
6. The machine and equipment need to be grounded effectively. If there is no ground wire in the power socket, it will produce static electricity, and users will often be exposed to static electricity.
7 in the CO2 CO2 laser marking machine work do not put your hand in the working range, because the CO2 CO2 laser marking machine 10.64um band laser beam hit on the hand will burn, if in the focal length range hit directly on the hand will break the flesh, so be careful.
If you wnat to know more,please contact us!
